When the ignition switch is. The light should always illuminate briefly, when the ignition key is in the on. It may be worth picking up a can of. Now put your jumper back on at the relay. Web the inlet air heater is used to improve start ability in cold weather and reduce white smoke. Watch the volt gauge for when it dips after you first turn the keyswitch on then after it starts rising, you can start the engine. Wait until the light goes off before starting. The other side of course won't be because the fuse is out. Web if you suspect a problem with the starting system (control box): Web wait to start under cold starting conditions, when the key is turned to the on position, a wait to start light illuminates on the dash.
The other side of course won't be because the fuse is out. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. The other side of course won't be because the fuse is out. This light will stay on for. Web wait to start light flashing and alarm chiming indicates there is excessive return fuel from the injector system. The ecm controls the heater and lamp through a relay mounted. Now put your jumper back on at the relay. Web the inlet air heater is used to improve start ability in cold weather and reduce white smoke. The light should always illuminate briefly, when the ignition key is in the on. When the ignition switch is. Once they heater stops it.